5/03/24
Out of abundance of caution we are issuing a recall for RCR-24 and RCR models that have a single firing pin bolt installed.
RCR 24's were shipped with the single firing pin bolt and some RCR's were updated with the single firing bolt.
The reported issue is that the Retaining Screw that attaches the Charging Flag to the bolt can back out over time and cause interference with the hammer, which can cause the rifle to discharge when charging.
We ask you to check your RCR to see if you have the below pictured bolt with the Retaining Screw.
RCR-24 Affected Serial Numbers
80519, 80518, 80517, 80516, 80515, 80513, 80512, 80511, 80182, 80181, 80180, 80179, 80178, 80177, 80176,
80175, 80174, 80173, 79329, 79328, 79327, 79326, 79325, 79324, 79323, 79322, 79321, 79320, 78757, 78756,
78755, 78754, 78000, 77999, 77998, 77997, 77996, 77995, 77994, 77993, 77992, 77991, 77990, 77989, 77988,
77987, 77986, 77985, 77984, 77983, 77982, 77981, 77980, 77979, 77978, 77977, 77976, 77975, 77974, 77973,
77972, 77971, 77970, 77968, 77967, 77966, 77965, 77964, 77963, 77962, 77960, 77002, 77002, 76801, 75994,
75993
If you have the above pictured bolt installed in your rifle discontinue use and complete the RMA form.
We will issue you a RMA and a UPS label so your rifle can be sent into our service department.
Your rifle will be updated to with a new style Charging Flag that does not use the Retaining Screw.
This issue affects a very small number of rifles, and doesn't affect any of our other Rifle or Pistol models.
Click Here for the RMA Form
